Tanaka AST-7000 Benutzerhandbuch

 

 

 
www.tanakapowerequipment.com                            7                                              custsvc@tanaka-ism.com 

(IV. Maintenance cont.) 

1.  When replacing blade, purchase one recommended by TANAKA, with a 

25.4 mm (one inch) fitting hole. 

2.  When installing saw blade, always face the stamped side up. In the case 

of a 4 tooth blade, it can be used on either side. 

3.  Use correct blade for the type of work. 

4.  When replacing blade, use appropriate tools. 

5.  When cutting edges become dull, re-sharpen or file as shown in figure. 

Incorrect sharpening may cause excessive vibration. 

 

1.  Completely drain fuel out of tank and run engine until it stops. 

2.  Clean the unit carefully and keep it from moisture. 

3.  In the case of transport or storage, switch off the engine. 

4.  When transporting in a vehicle, keep blade covered with blade cover.