Peerless Industries smart mount sf 16d Benutzerhandbuch

ISSUED: 08-02-05  SHEET #: 202-9010-1

Note: Read entire instruction sheet before you start installation and assembly.

• stud finder ("edge to edge" stud finder is recommended)

• drill

• 1/4" bit for concrete and cinder block wall

• 1/2" bit for metal stud wall

• 5/32" bit for metal or wood stud wall

• 3/8" socket wrench (socket with extended driver recommended)

• level

• 6 mm allen wrench

Parts List .............................................................................................................................................................................. 3

Installation to Single Wood Stud Wall ................................................................................................................................... 4

Installation to Double Wood Stud Wall .................................................................................................................................. 5

Installation to Solid Concrete or Cinder Block ....................................................................................................................... 6

Installing Interface Bracket to PLP Adapter Plate ................................................................................................................. 7

Installing Interface Bracket to LC Adapter Plate .................................................................................................................... 8

Installing Flat Panel Screen to Wall Plate ............................................................................................................................. 9

• Metal Stud Fastener Kit (ACC 415)

• Do not begin to install your Peerless product until you have read and understood the instructions and warnings

contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-729-0307.

• This product should only be installed by a qualified professional.

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-

ware and components.

• Never exceed the Maximum Load Capacity of 200 lb (90.7 kg).

• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an

"edge to edge" stud finder is highly recommended.

• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding

power.