Philips AZ1575 Benutzerhandbuch
English
BASIC FUNCTIONS
GENERAL INFORMATION
6
SWITCHING ON AND OFF
• Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE.
• The set is switched off when the POWER slider is in the
TAPE/OFF position and the keys on the tape deck are
released.
released.
– The volume, sound settings and tuner presets will be retained in
the set's memory.
ADJUSTING VOLUME AND SOUND
1. Turn the VOLUME/ SOUND CONTROL CENTER control
clockwise to increase or anti-clockwise to decrease volume on
the set (or press VOLUME
the set (or press VOLUME
+
or
–
on the remote control).
™ Display shows the volume level indication
VOL
and a number from
0-32.
2. To adjust the bass, mid and high frequency levels, press DIGITAL
EQUALIZER once or more until the desired option is displayed.
While the option is shown, turn the VOLUME/ SOUND
CONTROL CENTER control to increase or decrease
(- 5 to + 5 maximum) the desired frequency.
While the option is shown, turn the VOLUME/ SOUND
CONTROL CENTER control to increase or decrease
(- 5 to + 5 maximum) the desired frequency.
™ VOLUME can also be adjusted in this way with a level range
from 0-32.
3. Press DIGITAL DBB to switch dynamic bass boost on or off.
™ If on, the DIGITAL DBB light goes on.
4. Press INCREDIBLE SURROUND to switch the surround sound
™ If on, the DIGITAL DBB light goes on.
4. Press INCREDIBLE SURROUND to switch the surround sound
effect on or off.
™ If on, the INCREDIBLE SURROUND light goes on.
Note: The effect of INCREDIBLE SURROUND may vary with
different types of music.
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or direct
sunlight.
sunlight.
• To clean the set, use a soft, slightly dampened chamois leather. Do
not use any cleaning agents containing alcohol, ammonia, benzene
or abrasives as these may harm the housing.
or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
system from overheating.
• The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
AZ 1575 /01
page
6
CD
RE
CD S
Y
AZ 15
75
CD RA
DIO C
ASSET
TE RE
CORD
ER
STOP
PLAY
•PAU
SE
PRO
SOUN
D CO
BAT
L
SOU
ND C
ONTROL CENTER
VO
LU
M
E
CD REWRIT
ABL
E
CD SYNCR
O STRA
T R
AZ 15
75
CD RA
DIO C
ASSET
TE RE
CORD
ER
STOP
PLAY
•PAU
SE
SOU
ND C
ONTROL CENTER
VO
LU
M
E
+
–
•
•
•
•
•
•
•
•
0
VOL
XP AZ 1575/01 05-10-2000 09:23 Pagina 6