Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Philips
  4. dvdr3400-37b
  5. Benutzerhandbuch

Philips dvdr3400-37b Benutzerhandbuch

Download
Seite von 77
English
67
 Problem 
(General) 
Solution
Troubleshooting 
(continued)
No sound.
No TV signal received from 
the recorder.
A TV channel installed 
during the DVD recorder’s 
automatic TV channel 
search is fuzzy or distorted.
Unable to eject disc tray.
The contents of the USB 
fl ash drive cannot be read.
Slow operation of the USB 
fl ash drive.
No HDMI audio output.
No HDMI video output.
–  Check the audio connections, the red and white jacks. Read 
chapter “Step 1: Basic Recorder Connections - Connecting 
the audio cables” for details.
–  Set the Digital output correctly, based on the equipment 
you connected to the DVD recorder. Read chapter “DVD 
Setup Menu Options – PLAYBACK settings – Digital Audio 
Output” for details.
–   Have your antenna or cable TV signal checked. 
–  Install the TV channel. Read chapter “Step 3: Installation  
and Setup - Setting your TV channel programs” for details.
–  Check the video connection between the DVD recorder 
and the TV.
–  You can further fi ne-tune the signal of the TV channel.Read 
chapter on “DVD Setup Menu Options - CHANNEL SETUP 
Settings – Modify Channel Information.”
–  Press CH +/– to search for the same TV channel which may 
have a clearer picture. 
–  Exit from any system or recording setup menu until you see 
the Philips wallpaper on the screen.
–  Press STOP to stop any playback or recording. Then press 
EJECT on the set or press OPEN/CLOSE on the remote 
control to eject the disc tray.
–  The USB fl ash drive format is not compatible with the 
system.
–  Drive is formatted with a different fi le system which is not 
supported by this DVD system (e.g. NTFS.)
–  Large fi le size or high memory USB fl ash drive takes longer 
time to read and display on the TV.
–   You will not hear any sound from the HDMI output if the 
source device is only DVI/HDCP (High-bandwidth Digital 
Content Protection)-compatible.
–   It is not possible to output SACD or copy-controlled DVD-
Audio sources from the HDMI connection.
–  HDMI connection can only be made to HDMI-equipped 
devices with HDCP (High Bandwidth Digital Content 
Protection.)  If you wish to connect to a DVI connector 
(equipped with HDCP), you will need a separate adaptor 
(DVI to HDMI.)
–   Make sure the resolution of this DVD system matches the 
device you have connected using the HDMI.  See HDMI 
setting.
1_dvdr3400_37_eng_22151a.indd   67
1_dvdr3400_37_eng_22151a.indd   67
2007-02-26   11:54:30 AM
2007-02-26   11:54:30 AM