Philips mcd290 Benutzerhandbuch

31

See "Preparations-Step 2: Setting the clock".

●

The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.

1

In standby mode, press and hold TIMER for
more than three seconds.

➜

"

SET TIMER" is displayed briefly. Then, the

hour digits flash on the display panel.

2

Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the hours and press TIMER to confirm.

➜

The minute digits flash on the display panel.

3

Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the minutes and press TIMER to confirm.

➜

"

ON" or "OFF" flashes.

4

Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to
activate or deactivate the timer and press
TIMER to complete the setting.

➜

Display shows 

 if activated, and disappears

if deactivated.

The sleep timer enables the system to switch off
by itself after a set period of time.

1

Press SLEEP on the remote control repeatedly
to select a preset time.

➜

The selections are as follows (time in

minutes):
    

00 ™ 10 ™ 20 ™ 30 ™ 40 ™ 50 ™ 60 ™

70 ™ 80 ™ 90™ 00

➜

"

SLEEP XX" is displayed. "XX" is the time in

minutes.

2

When you reach the desired length of time, stop
pressing the SLEEP button.

●

Press SLEEP repeatedly until "

00" is displayed,

or press STANDBY ON 

y.

DISPLAY/ST

pg001-pg036_MCD290_98-Eng

2005.11.14, 14:50

31