Philips VR420CAT Benutzerhandbuch

Press the VCR button, then press the POWER button.
The VCR/TV light and the POWER light will appear on the VCR
display panel.

Turn on the TV. Set it to the same channel as the
CH3/CH4 switch on the back of the VCR. The display shown
below will appear on the TV screen. (If the display does not
appear, check your hookups, then follow the steps on page 12 to
set up channels and page 17 to select a language.)

Within 60 seconds, press the PLAY/o button or the
STOP/p button to select English or Spanish on-screen
displays and menus.

Press the MENU button. The display shown below will appear.

SELECT op

→

ENGLISH                     ON
ESPAÑOL

MAKE SELECTION OR
PUSH MENU TO CONTINUE

Within 60 seconds, press the CH(annel) o button to
begin automatic channel programming. AUTO CH PRO-
GRAMMING IN PROCESS PLEASE WAIT will appear on the
screen. The VCR will memorize all available channels. When all
channels are memorized, CHANNELS ARE SET will appear on the
screen briefly, then TV programming will appear.
Now, when you press the CH(annel) o/p buttons, you’ll only
scan through channels that you receive. You can still select other
channel numbers using the Number buttons.

immediately, insert a tape with its
record tab removed. Or, to skip step
3, press the MENU button. All on-
screen displays will be in English. To
skip step 5, press the STOP/p but-
ton.  Channels will not be pro-
grammed, and CHANNELS NOT
SET will appear on the screen.

when there is no antenna or cable
connected to the VCR, programming
will appear to take place, but even-
tually a NO TV SIGNALS message
will appear. Connect an antenna or
cable to the VCR’s ANT(enna) IN
Jack and press the CH(annel) o
button again. You may need to fol-
low the steps on page 12.

Before turning on your VCR, make sure batteries are in the
remote control and the VCR and TV are connected correctly.
Details are on pages five - 10.

●

You can not program channels if you are using a Cable Box or
a Direct Broadcast System.

Turn on the TV. 

CONNECT ANTENNA OR CABLE
TO VCR

THEN  .  .  .

PUSH CH UP KEY

OR  .  .  .

FOR PLAY ONLY – PUSH STOP