Pfaff 1183 Benutzerhandbuch

24

8

.05 

Basic position of the machine drive unit 

8

.05.01 

On machines with EcoDrive and control unit P40 ED 

 

● Switch on the machine.

 

● Press the TE/speed key twice to select the input mode. 

 

● Select parameter "798" by pressing the corresponding +/- key, and select service level 

C, see Chapter Selecting the user level in the instruction manual for the control panel.

 

● By pressing the corresponding +/- key select the parameter "799" (Selecting the machine 

class).

 

● Check whether value "1" is set, and correct it if necessary.

If the parameter has to be altered, operate the TE/Speed key and then switch 

off the machine and switch it on again. Then select service level C again as de-

scribed above.

 

● By pressing the corresponding +/- key, select parameter "800" (selecting the sewing 

direction).

 

● By pressing the corresponding +/- key, select the value for the parameter at "0".

 

● By pressing the corresponding +/- key, select parameter "700".

 

● Sew a stitch by operating the pedal.

 

● Turn the balance wheel in the sewing direction until the descending needle is level with 

the top edge of the needle plate.

 

● Then check the parameter values listed in the parameter list (see Chapter 

10.04 Parameter Settings) and adjust them if necessary.

 

● Conclude the adjustment of the sewing motor by pressing the TE/Speed key.

8

.05.02 

On machines with PicoDrive and control unit P40 PD2

 

● Switch on the machine.

 

● Call up the parameter input by pressing the "scroll" key.

 

● To switch the function keys to input (LED in the TE key lights up), press the TE key.

 

● By pressing the corresponding +/- keys, select parameter "798" and service level C, 

see Chapter Selecting the User Level in the separate Control Panel Instruction Manual.

 

● Select parameter "799" by pressing the corresponding +/- keys.

 

● Check whether the value is set at "2" and alter if necessary.

 

● Switch the machine off and then on again.

 

● Select parameter "800" by pressing the corresponding +/- keys.

 

● Check whether the value is set at "0" (balance wheel turns towards the operator) and alter 

if necessary.

 

● Select parameter "802" by pressing the corresponding +/- keys.

 

● Check whether the value is set at "0" (= no reduction ratio) and alter if necessary.