Maytag mle-mlg23pra Benutzerhandbuch
8
16022904 Rev. 0
©2004 Maytag Appliances Company
TERMINOLOGY/DEFINITIONS
TERM
DEFINITIONS
Amperage
-
The amount or the rate of flow of electrical current.
Booster Coil
-
A coil used to assist the holding coil to raise the plunger in the gas valve allowing gas to
flow
into the second chamber of the valve.
BTU
-
British Thermal Unit is the quantity of heat required to raise the temperature of one pound of
water 1
o
F.
Centrifugal
-
A switch device in a motor used to change the path of electricity from both start and run
winding to run winding only. It also completes the circuit to the heat source when motor
reaches speed.
winding to run winding only. It also completes the circuit to the heat source when motor
reaches speed.
CFM
-
Air movement measured in cubic feet per minute.
ClothesLifters -
Devices attached to the inside of the tumbler used to lift and tumble the clothes during
operation of the dryer.
operation of the dryer.
Coin Drop
-
A device which accepts and registers the number and denomination of coins used to start
the
dryer.
Duct
-
A construction of aluminum or galvanized steel pipe used to convey moisture laden air from
the dryer to the outside.
Evaporation
-
The process of expelling moisture from garments by heat and/or air movement.
Exhaust Hood -
A damper placed at the terminating end of the ducting which prevents air from entering the
duct when the dryer is not running.
Glide Strip
-
A stationary bearing surface at the front on which the dryer tumbler turns.
Holding Coil
-
A coil used to open the first valve in the gas valve assembly. It holds the valve open after
the initial assistance from the booster coil.
the initial assistance from the booster coil.
Igniter
-
A silicon carbide igniter located on the burner bracket near the main orifice. It can reach a
temperature of 2200
temperature of 2200
o
F. in 30 seconds to ignite the gas (when allowed to flow through gas
valve orifice).
Light Emitting -
A solid state indicator unit found as a single light and in a display Diode arrangement to
form
numbers and letters.
Manometer
-
An instrument for measuring the pressure of gas or air.
Microprocessor-
The "brains" of the control board. A solid state "count and switch" processor device.
OHM
-
A unit of measurement of resistance (opposition to the flow of current).
Parallel Circuit -
A circuit in which there is more than one current path.
Radiant Sensor-
Thermostat-like device which reacts to the brightness or radiant energy output of a heat
source.
source.
Sensor Relay
-
A coil operated switch used to control dryer motors, heating element or gas valve on
computer models.
computer models.
Relay
-
A coil operated switch used to control dryer motors, heating element or gas valve on
Computer models.
Computer models.
Resistor
-
A device used to limit the flow of current or reduce voltage.
Run Winding
-
The main electromagnetic winding in a motor.
Series
-
A circuit in which there is only one current path through all components.
Start Winding -
(Phase winding) An auxiliary winding used in an A.C. motor to assist the main winding in
developing starting torque.
developing starting torque.
Thermostat
-
A bimetal switch which reacts to temperature changes.
Tumbler
-
Cylinder which contains and tumbles clothes.
Voltage -
Electric pressure that forces the current to flow in a circuit.
Wattage
-
Wattage is a unit of measurement of the capability of electricity to do work.
General Information