Interphase Tech ispan 5535 pri Benutzerhandbuch

The following general safety precautions must be observed during all 
phases of operation of this equipment. Failure to comply with these 
precautions or with specific warnings elsewhere in this manual violates 
safety standards of design, manufacture, and intended use of the 
equipment. Interphase Corporation assumes no liability for the user’s 
failure to comply with these requirements. As the user of the product, 
you must observe all stated warnings and safety precautions in order to 
safely operate the equipment in your environment.

Because of the danger of introducing additional hazards, do not install 
substitute parts or perform any unauthorized modification of the 
equipment. Contact your local Interphase representative for service and 
repair to ensure that safety features are maintained.

To minimize shock hazard, the equipment chassis and enclosure must be 
connected to an electrical ground. The power cable must either be 
plugged into an approved three-contact electrical outlet or used with a 
three-contact to two-contact adapter, with the grounding wire (green) 
firmly connected to an electrical ground (safety ground) at the power 
outlet.

Do not operate the equipment in the presence of flammable gases or 
fumes. Operation of any electrical equipment in such an environment 
constitutes a definite safety hazard.

Do not install or replace the component with power cables connected. 
Under certain conditions, dangerous voltages may exist even with the 
power cable removed. To avoid injuries, always disconnect power and 
discharge circuits before touching them.