Dakota Digital lat-nr251 Benutzerhandbuch

LED Tail Lights for 1968 Impala 

 

MAN#650211 

 

 

1.  Remove all tail light lenses as described below while taking care to keep 

the lenses with their housings.  

2.  Remove the three screws that hold the lens in and remove the lens from 

the housing.  

3.  Remove the light bulb from socket.   
 
4.  Now is a good time to clean the lenses and the tail light housings. If the 

lenses are in poor condition a replacement set is recommended. 

 

5.  Make sure the housings and lenses are clean and dry. Test fit the LED 

assemblies by placing the LED assemblies in housings to check for a good fit. DO NOT 
remove the backing from the tape yet! Note the places where the tape touches the housing.  

  

   

 

 

6.  Squeeze the primer tube to break the glass bulb and wet the brush end with primer. Rub the 

primer on the housings at the places where the tape will touch. Treat all tail light housings at 
the same time before the primer tube dries out.