Intermatic ig1300 installation Benutzerhandbuch

Electricity is dangerous if safety rules
are not followed.  Never work on equip-
ment with the electricity turned 'ON'.  Be
absolutely certain the power is turned
‘OFF' on the circuit or device you are
installing or repairing.  If you are not
able to determine that power is removed
have it checked by a licensed electri-
cian.  Be sure you read carefully and
understand all of these installation steps
and have the necessary tools and sup-
plies before you begin to install the pro-
tector.  Check and follow your local elec-
trical codes, they are for your protection.

When installing outdoors, care must be taken to comply with all local and national elec-
tric codes regarding outdoor or wet locations. Do not touch electric devices when you
are wet or you are standing on a wet surface.  Use a circuit tester or AC voltmeter to be
sure the electricity is "OFF' before you touch wires or devices. 
Install Telephone protection per Article 800 of the National Electrical Code on the equip-
ment side of the primary telephone Listed equipment.

STEP 1
Verify that all parts are included for your system.

DESCRIPTION

QUANTITY

QUANTITY

(IG1300-2T-1C)

(IG1300-4T-2C)

PanelGuard IG1300 AC Voltage Protection Device

1

1 

with 30” wire leads

Mounting Plate

1

1 

Wire channel cover

1

1 

4-wire (2-pair) Telephone protection module

1

2 

1-circuit coaxial cable protection module

1

2 

STEP 2
Tools and additional materials required.
AC Voltmeter or Voltage tester
Screwdrivers

Flat or phillips blade for cabinet mounting screws. 
Torx T-20 for internal screws

Lineman’s pliers or wire strippers
Hammer (optional) 
3 each 1-1/4” x #10 sheet metal, wood or masonry screws