Dimplex ROD20 Benutzerhandbuch

 

Glen Dimplex UK Limited
Millbrook House
Grange Drive
Hedge End
Southampton
Hampshire.  SO30 2DF

UK customer help line (8.00AM – 6.00PM Mon-Fri; 8.30AM-1.00PM Sat)

Customer Services:

 Tel.

0870 7270101

 Fax.

0870 7270102

 e-mail

customer.services@glendimplex.com

Republic of Ireland

 Tel.

01 8424833

The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility
(EMC) EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336

Your appliance is guaranteed for one year from the date of
purchase. We undertake to repair or exchange free of charge
within this period, any part with the exception of a lamp found
to be defective due to a manufacturing fault.

Your rights under this guarantee are additional to your statu-
tory rights, which in turn are not affected by this guarantee.

Please retain your receipt as proof of purchase.

At the rear of the fire, two adjustable supports are provided for
levelling the fire where the base of the fireplace opening is
raised above  the level of the hearth.

Adjust by removing the two screws holding each bracket in
position, then refit the bracket and the two screws in the re-
quired position.

The metal surround at the rear of the fire may be removed if
full inset of this fire is required.

The unique flame effect may be enjoyed whether or not the
heating elements are in operation.

The heater controls are located on the right hand side of the
canopy heat outlet.

Three switches provide a choice of heat settings.
A switch is in the ON position when the red indicator mark on
the switch is visible.

Switch 1 - Controls the electricity supply to the heater

 and the flame effect.

 Note: This switch must be in the ON position
 for the heater to operate.

Switch 2 - Provides 1kw heat output.

Switch 3 - Provides 2kw heat output with switch 2.

 

There is one lamp located beneath the fuel effect. To gain
access to the lamp, remove the coal and place in a con-
tainer, lift out the plastic fuel effect to reveal the lamp.
Replace the defective lamp with a 240V 60W fire glow 2 pin
bayonet cap lamp.
Replace plastic fuel effect and coals.

For your safety, this appliance has been fitted with thermal
cut-out. In the event that the product overheats, the cut-out
switches the heat off automatically.
To bring the heat back into operation, remove the cause of
the overheating, then unplug or turn off the electrical supply
to the heater for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch
on the heater.

Before commencing cleaning, unplug the heater and allow it
to cool.
The surfaces of the heater should be given an occasional
wipe over with a dry soft cloth.
Do not use detergents, abrasive cleaning powder or polish
on the metal body of the heater.

The glass screen should be cleaned carefully with a chamois
leather. DO NOT use proprietary cleaners.

To remove any accumulation of dust or fluff the soft brush
attachment of a vacuum cleaner should occasionally be used
to clean the outlet grille of the fan heater located under the
canopy.
To clean the fuel effect, remove the coal pieces and wash in
warm water. The plastic tray should be wiped clean with a
damp cloth. When dry replace the coal pieces and arrange
for best effect.