cortech datalog 3-cyclops frame store cctv Benutzerhandbuch

Cyclops Frame Store CCTV Module V1.0 - Page 1 of 1

CORTECH DEVELOPMENTS LTD

Datalog software module for operation with the VRC Cyclops freeze frame unit, to control the recording of
alarm frames by the Cyclops.

The Datalog software will upon alarm provide control signals to a suitable output relay provided by the
installer. This output should be connected by the installer to the alarm input for camera one. On the
first alarm this output will trigger the frame store. Because of the speed limitations of clearing the
Cyclops frame store before further alarm triggering, only the first alarm will trigger storage.

When an alarm is ‘Accepted’ by an operator, then the Datalog will select camera 1 channel. Once any
alarm is reset by the operator, the Datalog will issue the following key press actions automatically via
an RS232 port.

1. Clear
2. Clear

Since the keyboard port only supports one keyboard, the Cyclops keyboard must be disabled in order
for correct operation.

The Cyclops unit should be programmed as follows:

•

  Camera 1: Capture all frames after trigger

•

  Alarm sequence: Autoplay Mode

Rx

Gnd

Tx

Ov

Notes: Cyclops on Datalog port COM4, Alarm = C-Lem 49

Com

Port

8

7

6

Alarm
Cam 1

Relay