Lennox gas stove Benutzerhandbuch

The air shutter control lever is located on the bottom of the

stove directly to the left of the gas valve. The lever is linked

to the primary air shutter on the main burner. The air shutter

regulates the amount of primary air the burner receives and,

therefore, how clean the stove burns. The air shutter should

only be adjusted by a qualified gas technician. The stove

should burn for about 15 minutes with the logs installed

before adjusting the air shutter. Moving the lever to the left

will open the shutter and turn the flames more transparent

and blue. Moving the lever to the right will close the shutter

and turn the flames more orange. Caution:  The air shutter 

As the Vision gas stove is burning, a number of normal op-

erational sounds may be heard. The flow of gas through the

gas valve and orifice may make a rushing or whistling noise.

If this noise is objectionable, it can be reduced by turning

down the flame. Turning down the flame can reduce total

heat output by more than 30%. When the blower turns on,

the sound of rushing air may be heard. The blower sounds

may be reduced by adjusting the speed control located on the

blower assembly. Also, a slight clicking sound may be heard

as the gas valve or blower switch is turned on and off.

This stove has been painted with StoveBright high tempera-

ture metallic paint. It leaves the factory dry to the touch, but

completes the curing process as the stove is used. To cure

the paint, burn the appliance four successive times for ten

minutes each time with a five minute cool down between

each firing. Also some parts of the appliance may be lightly

coated with machining oil. Ventilate the house during these

first firings as the paint and oil give off carbon dioxide and

unpleasant odors. It is recommended that persons sensi-

tive to an imbalance in the indoor air quality avoid the stove

during the curing process.