GE EPM 5200 Benutzerhandbuch

 

CHAPTER 16: ETHERNET OPTION 

95 

 

 

 
After entering Setup Mode (confirm by pressing Enter), you an configure the parameters by entering one 
of the numbers on the Change Setup Menu, or you can confirm default values by pressing Enter.  Be 
sure to store new configurations when you are finished. The Ethernet Interface will then perform a power 
reset. 
 
Serial Number 5415404  MAC Address  00:20:4A:54:3C:2C 
Software Version V01.2 (000719) 
Press Enter to go into Setup Mode 
 

1) Network/IP 

Settings: 

Ethernet Interface Autodetect 
IP Address 

 

 

- 0.0.0.0/DHCP (Customer Configurable) 

Default Gateway 

 

--- not set  ---     (Customer Configurable) 

Netmask 

 

 

--- not set  ---     (Customer Configurable) 

2)  Serial & Mode Settings: 

Protocol 

 

 

Modbus/RTU, Slave(s) attached (FIXED) 

Serial 

Interface 

  9600,8,N,1,RS232,DB25 (must match meter) (FIXED) 

3) Modem 

Control 

Settings: 

DCD 

Output 

  Fixed 

High/Active 

CTS Output 

 

 

Fixed High Active 

4)  Advanced Modbus Protocol Settings: 

Slave Addr/Unit Id Source 

Modbus/TCP header (FIXED) 

Modbus Serial Broadcasts 

Disabled 

Character, Message Timeout   00010 ms, 00500 ms 

 
D) default settings, S) save, Q) quit without save;  
select command or parameter set (1..4) to change: I 
 
BAUD RATE 
 
The Ethernet Interface and attached serial device (the meter) must agree on a speed or baud rate used 
for the serial connection.  Valid baud rates are 1200, 2400, 4800 and 9600 (default).  For the EPM 5350P, 
default settings are 9600 baud rate, 8 data, 1 stop, no parity, Modbus RTU.