Hitachi 31cx4b, 31ux5b Benutzerhandbuch
SAFETY TIPS
7
and uneven surfaces may cause the appliance and cart combination to overturn.
PROTECTION AND LOCATION OF YOUR SET
12 Do not use this television set near water, for example, near a bathtub, washbowl, kitchen sink, or
laundry tub, in a wet basement, or near a swimming pool, etc.
12 Do not use this television set near water, for example, near a bathtub, washbowl, kitchen sink, or
laundry tub, in a wet basement, or near a swimming pool, etc.
l Never expose the set to rain or water. If the set has been exposed to rain or water, unplug the set
from the wall outlet and refer servicing personnel.
from the wall outlet and refer servicing personnel.
13 Choose a place where light (artificial or sunlight) does not shine directly on the screen.
14 Avoid dusty places, since accumulated dust inside the chassis may cause failure of the set when
high humidity persists.
15 The set has slots, or openings in the cabinet for ventilation purposes, to provide reliable operation
of the receiver, and to protect from overheating. These openings must not be blocked or covered.
high humidity persists.
15 The set has slots, or openings in the cabinet for ventilation purposes, to provide reliable operation
of the receiver, and to protect from overheating. These openings must not be blocked or covered.
l Never cover the slots or openings with cloth or other material.
l Never block the bottom ventilation slots of the set by placing it on a bed, sofa, rug, etc.
l Never place the set near or over a radiator or heat register.
l Never place the set in a "built-in" enclosure, unless proper ventilation provided.
PROTECTION AND LOCATION OF YOUR SET
16-1 If an outside antenna is connected to the television set, be sure the antenna system is protected
against voltage surges and built up static charges, Section 810 of the National Electrical Code,
16-1 If an outside antenna is connected to the television set, be sure the antenna system is protected
against voltage surges and built up static charges, Section 810 of the National Electrical Code,