Hitachi cg2026s Benutzerhandbuch

GB   - 7 -

Before Switching on your TV

Power connection

IMPORTANT: The TV set is designed to operate on 220-240V

AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambient room

temperature before you connect the set to the mains.

Connections to the RF input socket

• Connect the aerial or cable TV plug into the RF input socket

on the back of the TV.If you are also connecting a video re-

corder /satellite receiver, plug the aerial into this equipment

first and then connect the RF output socket from this device

to the RF input on the back of the TV.

9+)8+)

:

795($53$1(/

&$%/(79

How to connect other devices

IMPORTANT: Switch off the TV before connecting any external

device.
Sockets for external connections are at the back of the TV. For

connection of other devices via Euroconnector refer to the

manuals of the related devices.

Inserting batteries in the remote control

handset

• Place the batteries in the right directions as seen below.
• Remove the battery cover located on the back of the handset

by gently pulling upwards from the indicated part.

• Insert two AAA (R03) or equivalent type batteries inside.
• Replace the battery cover.

Switching the TV ON/OFF

To switch the TV on

Your TV will switch on in two steps:
1- Press the power button located on the front of the TV. Then

the TV switches itself to standby mode and the RED LED

located below the TV turns on.

2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a programme

number is selected,
or,
Press Programme Up or Down buttons on the front of the TV

or on the remote control, so that last switched off programme

is selected.
In either case the TV will switch on and the RED LED will turn

to GREEN.

To switch the TV off

• Press the stand-by button on the remote control, so the TV will

switch to stand-by mode and the GREEN LED will become

RED,

or,
Press the power button located on the front of the TV, so the TV

will switch off and the GREEN LED will turn off.

Operating the TV

A.P.S. (Automatic Programming System)

"PLEASE, CHECK ANTENNA CABLE. AUTO PROGRAMMING

SYSTEM" message will be displayed when you turn on your TV

for the first time. A.P.S., searches and sorts all channels and

stores them automatically on your TV, according to the trans-

mission of programme systems in your area.

To cancel A.P.S. before starting, press “

79

” button. First of all

choose the “COUNTRY”.
The "STANDARD" setting is fixed to "BG". You cannot change

this item's setting. This, will effect the sort process in A.P.S.. To
select “START” use “ “ or “ ” button and press “ ” or “ ”
button. To cancel A.P.S. during running press “ ” or “ ” but-

ton.

3/($6(&+(&.$17(11$&$%/(

$872352*5$00,1*6<67(0

&28175<

67$1'$5'

67$57

'

%*

$36,65811,1*

39+)

&$1&(/

After A.P.S. is finalized, a programme list will apper on the

screen. In the programme list you will see the programme

numbers and names assigned to the programmes.
If you do not accept the locations and / or the programme

names of programmes, you can change them in Programme

menu.

01-ENG-(CG2026S)-5186-AV-3040-AK30-MN1P-PLLFS-BG-50051298.p65

13.07.2004, 13:19

7