GE zv881wss Benutzerhandbuch

12

Installation

5

Step

If house wiring is not 2-wire with a
ground wire, a ground must be
provided by the installer.
When house wiring is aluminum,
be sure to use U.L. approved anti-
oxidant compound and alumi-
num-to-copper connectors.

• Connect white lead to branch circuit white

lead.

• Connect black lead to branch circuit black

lead.

• Connect green lead to branch circuit green

or bare ground lead.

• Secure all connections with wire nuts on

each electrical connector.

Duct Tape
Over Seam and Screw

Screw

Air

Flow

Cut a length of duct to connect hood flange to
the ductwork.
• Install ductwork, making connections in

direction of airflow as illustrated.

• Secure joints in ductwork with sheetmetal

screws.

• Wrap joints with duct tape for airtight seal.

Transition duct pieces are available for 48"
wide models.
ZX48AY, 4-1/2" x 18-1/2" transition to 10"
round straight up exhaust.
ZX48BY, 4-1/2" x 18-1/2" transition to 10"
round direct to rear exhaust.
Call your GE Dealer to order.

Step

6

Hold the liner below the installed hood.
• Reconnect the male/female connector plug

to heat lamp and one to blower.

• Carefully, slide liner into installed hood.
• While holding in place, re-install the original

screws. Make sure that all screws have been
re-installed.

• Re-install light assembly with original screws.

7

Step

Reconnect Male/Female
Connector Plug

Connect to
Junction Box

Replace Screws That 
Hold Inner Liner in Place.

To Blower Motor

Hood Inner Liner