Mackie TT24 Benutzerhandbuch

Mackie TT24 Digital  Live Console Owner’s Manual

Rear Panel Connectors

44

These 

¼-in TRS connectors accept a balanced or unbalanced line level input 

signal from almost any source. The LINE button on the console surface should 

be in the 

down

 position when using these connectors. The LINE inputs appear 

on the ANALOG bank.

A balanced line level signal must be wired as follows:

• Tip = Positive (+ or hot)

• Ring = Negative (- or cold)
• Sleeve = Shield or ground

An unbalanced signal must be wired as follows:

• Tip = Positive (+ or hot)

• Sleeve = Shield or ground

These 

¼-in TRS connectors provide each channel an analog send and return 

point. Use the INSERT jacks to connect external serial effects devices (i.e., 

compressors, equalizers) to an individual channel. These connectors can also be 

used as post gain control, unbalanced channel direct outputs.

The INSERT points are after the GAIN control, and just before the ADC. The 

send (tip) is low-impedance and the return (ring) is high-impedance, allowing 

connection to virtually any device.

Cables for this type of insert send/return function must be wired as follows:

• Tip = Send (output to effects device)

• Ring = Return (input from effects device)

• Sleeve = Common ground (connect shield to all three sleeves)