GE 82-POE Benutzerhandbuch
GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual
217
Chapter 9
Troubleshooting
This chapter contains information to help you solve common problems. If the
Ethernet Switch is not functioning properly, make sure the Ethernet Switch was set up
according to the instructions in this manual.
The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of the Ethernet Switch
Some stations cannot talk to other stations located on the other port
Solution:
Check the VLAN settings, trunk settings, or port enabled / disabled status.
Performance is poor
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full
duplex and the partner is set to half duplex, then the performance will be poor. Please
also check the in/out rate of the port.
Why the Switch doesn't connect to the network?
Solution:
1. Check the LNK/ACT LED on the switch
2. Try another port on the Switch
3. Make sure the cable is installed properly
Ethernet Switch is not functioning properly, make sure the Ethernet Switch was set up
according to the instructions in this manual.
The Link LED is not lit
Solution:
Check the cable connection and remove duplex mode of the Ethernet Switch
Some stations cannot talk to other stations located on the other port
Solution:
Check the VLAN settings, trunk settings, or port enabled / disabled status.
Performance is poor
Solution:
Check the full duplex status of the Ethernet Switch. If the Ethernet Switch is set to full
duplex and the partner is set to half duplex, then the performance will be poor. Please
also check the in/out rate of the port.
Why the Switch doesn't connect to the network?
Solution:
1. Check the LNK/ACT LED on the switch
2. Try another port on the Switch
3. Make sure the cable is installed properly