Cub Cadet 930 SWE Benutzerhandbuch

1.  Remove the chute crank rod from the chute crank assembly 

by removing the hair pin clip shown in Fig. 7-1. Move the 

chute crank rod away from the assembly as shown. 

2.  Remove the plastic belt cover on the front of the engine 

by removing the three self-tapping screws. See Fig. 7-2.

3.  Loosen the bolt shown in Fig. 7-3 securing the belt 

keeper bracket and remove the other bolt. Push the belt 

keeper bracket up off the engine pulley. See Fig. 7-3.

To remove and replace your snow thrower’s auger belt, 

proceed as follows:
1.  Remove the bow-tie clip and flat washer from the 

ferrule in order to disconnect the auger idler rod from 

the brake bracket assembly. See Fig. 7-4.

Make sure to maintain the location of the 

ferrule on the idler rod. 

2.  Slip the auger control belt (the front belt) off the engine 

pulley. 

Ferrule

Auger Idler Rod

Bow-tie Clip 
and Washer