Cub Cadet 933 SWE Benutzerhandbuch

1. 

Place the shift lever in the fastest forward speed position.

2. 

Loosen the hex  nut on the shift cable index bracket. See 

Fig. 6-4.

3. 

Pivot the bracket downward to take up slack in the cable. 

4. 

Retighten the hex nut.

NOTE: There are extra holes in the speed slector bracket 

shown in Fig. 6-4 for further adjustment of the cable if 

required.

If the spiral at the bottom of the chute directional control is not 

fully engaging with the chute assembly, the chute bracket can be 

adjusted. To do so:
1. 

Loosen the two nuts which secure the chute bracket and 

reposition it slightly. See Figure 6-5.

2. 

Retighten the nuts.

Once a season, lubricate the eye-bolt bushing and the spiral with 

3-in-1 oil.

At least once a season, one at a time, remove the shear pins from 

the  auger shaft. Spray lubricant inside the hub of each auger 

spiral assembly and around the spacers on the auger shaft. See 

Figure 6-3.
Grease fittings can also be found at each end of the auger shaft. 

Lubricate with a grease gun once a season. See Figure 6-3.

The auger gear case is equipped with a grease fitting. Lubricate 

with grease once a season (order part number 737-0168). See 

Figure 6-3.

NOTE: To relieve pressure, remove the vent plug before 

lubricating the gear case. See Figure 6-3. Failure to do so could 

result in damage to the gear case seals. 

Each of the auger spiral assemblies is secured to the spiral shaft 

with a shear pin and cotter pin. If the auger should strike a 

foreign object or ice jam, the snow thrower is designed so that 

the pins may shear.  
1. 

If augers do not turn, check to see if pins have sheared. 

2. 

Replace the pins if needed. Two replacement shear pins 

and cotter pins have been provided with the snow thrower. 

Spray an oil lubricant into shaft before inserting new pins 

and securing with new cotter pins.

If the full range of speeds (forward and reverse) cannot be 

achieved, refer to the Figure 6-4 and adjust the shift cable as 

follows: