ICOM ic-m801gmdss Benutzerhandbuch

63

13

CONNECTION AND INSTALLATION

■ Connector information (continued)

NOTE: The IC-M801GMDSS supports IEC61162-1: 2000 data with FSI, SFI DSC and DSE sentences only.

NOTE: The IC-M801GMDSS supports IEC61162-1: 2000 GPS data with GGA, GNS, GLL and RMC sentences, and UTC of

position (excludes second unit or less), latitude and longitude information only.

1

DATA-OUT (–) Ground (not transceiver’s ground) for 

DATA-OUT (+) terminal.

2

DATA-OUT (+) IEC61162-1: 2000 data output. 

Output level

: 40 mA max. (as a talker)

3

DATA-IN (+) IEC61162-1: 2000 data input. 

Input level

: Less than 2 mA (when 2 V

applied; as a listener)

4

DATA-IN (–) Ground (not transceiver’s ground) for 

DATA-IN (+) terminal. 

5

GND

Connected to the ground.

6

NC

No connection.

7

NC

No connection.

8

NC

No connection.

9

NC

No connection.

1

5

6

9

Front panel view

GPS IN (+) GPS data input in IEC61162-1: 2000 format. Input level : Less than 2 mA (when 2 V ap-

plied; as a listener)

GPS IN (–) Ground (not transceiver’s ground) for GPS-

IN (+) terminal.

GPS IN (+)

RCA

GPS IN  (–)

1

STROBE

Outputs a strobe pulse after data output.

2–9

DATA1–8

Outputs 8-bit parallel data.

10

ACKNLG

Input port for the connected printer.
“Low” pulse signal is applied from the printer during the printer accepts data input.

Input port for the connected printer.

11

BUSY

“High” level signal is applied from the printer during the printer cannot accept data
input, such as when off line.

12–14

NC

No connection.

15

ERROR

Input port for the connected printer.
The printer output becomes “Low” when an printer error, such as no paper, occurs.

16, 17

NC

No connection.

18–25

GND

Ground terminals.

13..........................1

25.......................14

Front panel view