Hitachi 35ux60b, 35tx10b Benutzerhandbuch

USING THE GENIUS REMOTE TO CONTROL CABLE BOX FUNCTIONS 

 

51

This Genius Remote is designed to operate different types of cable boxes. You must 
first program the Genius Remote to match the remote system in your cable box. (Refer 
to Table 2 on page 36 or Table 4 on page 37.) 
1. Set the MULTI-PAGE select switch to "CATV". 
2. Set the USE/LEARN mode select switch to "USE." (For CLU-850GR only) 
3. Turn ON your cable box. 
4. Aim the Genius Remote control at the front of your cable box. 
5. While holding down the SELECT button, press the button that matches our cable box 
as shown on page 36 or page 37. Continue to hold down both buttons. The channels of 
the cable box will begin changing when the correct button is pressed. When this occurs, 
the Genius Remote Control is programmed for your cable box. If the cable box channels 
do not change after 5 seconds, try a different Genius Remote button. 
6. Release both buttons when the cable box starts to change channels. The Genius 
Remote will now control your cable 

Click here to see the CLU-850GR in the CATV position. 

NOTES: 
1. If your cable box cannot be operated after performing the above procedures, this means 
that your cable box codes have not been precoded into the GENIUS REMOTE. Please 
store your cable box codes in memory by using the USER mode. (Refer to page 38.) 
2. The GENIUS REMOTE CONTROL will remember the codes you have programmed in 
until the batteries are removed from the GENIUS REMOTE CONTROL. After replacing the 
batteries repeat the entire programming procedure stated above. 

These buttons always transmit the chosen precoded CATV codes. 

This is for setting up the cable box's Pre-code. 

These buttons are for operating the TV.