Oregon bar908hgu Benutzerhandbuch

EN

16

MAXIMUM / MINIMUM MEMORY FOR UVI
To view the maximum and minimum memory for UVI:

1.  Press SELECT to navigate to the Barometer Area. 
2.  Press MODE to select the UV display.
3.  Press  MEM  to  show  maximum,  minimum  and   

current UVI readings.

4.  Press  and  hold  MEM  for  2  seconds  to  clear  the   

UVI memory.

NOTE The UV sensor must be activated before you try and 
set the additional features. 

The  weather  station  can  display  the  following  information 
from any of the 5 remote sensors:

•  Current,  minimum,  and  maximum  temperatures   

and relative humidity percentages.

•  Comfort  level  indicator  and  trend  line  (rising,   

falling, or steady).

Data  is  collected  and  displayed  approximately  every   
60 seconds.

Press SELECT to navigate to the Temperature and Humidity 
Areas.
Temperature data is given at the top; Humidity is below.

Slide  the  °C  /  °F  switch  (inside  the  clock  battery 
compartment), to the setting you want. 

Press CHANNEL to switch between sensors 1-5.

•  To  auto-scan  between  sensors,  press  and  hold   

CHANNEL  for  2  seconds.  Each  sensor’s  data  will   
be displayed for 3 seconds. 

•  To  end  auto-scan,  press  CHANNEL  or  MEM   

with the Temperature / Humidity Area selected.

NOTE If you select a sensor that collects only temperature 
data, the humidity will not be shown.

•  Press 

MEM 

repeatedly 

to 

view 

current,   

maximum  and  minimum  records  for  the  selected   
sensor. 

•  To  clear  the  records,  press  and  hold  MEM   

for  2  seconds.  A  beep  will  sound  to  confirm  that   
the memory has been cleared.

The  trend  lines  are  shown  next  to  the  temperature  and 
humidity readings.