Crestron caen-ck-7x1 7x2 Benutzerhandbuch

 

 

The CAEN-CK-7x1 & 7x2 CAEN Cover Extension Kits 
are designed to increase the overall depth of the CAEN-
7x1 and CAEN-7x2 automation enclosures by 1.5 inches. 
Adding depth to these enclosures allows the enclosure to 
accommodate excess wiring and third-party devices that 
may not normally fit in the standard enclosure. 

HORIZONTAL

PAN (x2)

W

D

H

VERTICAL

BRACKET (x4)

 

The following table lists the dimensions for the  
CAEN-CK-7x1 and CAEN-CK-7x2. 

H 

62.00 in 

62.00 in 

D 

1.50 in 

1.50 in 

W 

15.35 in 

26.50 in 

The cover extension kit should be attached to a Crestron

®

 

Automation Enclosure in accordance with all national and 
local electrical codes. The enclosure cover and screws 
must be removed prior to installation. Both must be 
retained and used with the supplied screws to complete 
the following procedure.  

Refer to the following procedure shown in the installation 
diagram when installing the CAEN Cover Extension Kit. 

 

1.  As shown in the installation diagram, place a 

horizontal pan on the bottom and top of the CAEN 
enclosure (edges facing inward). Use a #2 Phillips 
tip screwdriver to secure the horizontal pans to the 
enclosure using the 8-32 screws. 

 

 

15 Volvo Drive   Rockleigh, NJ 07647

   

Tel: 888.CRESTRON

 

Fax: 201.767.7576

Specifications subject to 

www.crestron.com

change without notice.