Hoyt recurve-2000 Benutzerhandbuch
BOW ASSEMBLY
Installing Detent Limbs (Standard Risers)
Install one limb in each pocket (the limb noting specifications is
the bottom limb). Carefully insert the limb bushing into the
dovetail groove in the pocket. Push the limb forward until the
detent button engages. You should hear a “click” indicating the
limb is fully seated.
Hoyt limbs are available in marked weights from 22# to 50# in
two pound increments. The weight marked on the lower limb is
measured at a 28” standard A.M.O. (Archery Manufacturers and
Merchants Organization) draw length. A.M.O. draw length is
measured at 26 1/4” to the throat of the bow grip plus 1 3/4”.
This produces an industry standard by which recurve bows are
measured.
two pound increments. The weight marked on the lower limb is
measured at a 28” standard A.M.O. (Archery Manufacturers and
Merchants Organization) draw length. A.M.O. draw length is
measured at 26 1/4” to the throat of the bow grip plus 1 3/4”.
This produces an industry standard by which recurve bows are
measured.
Note: Your draw weight will change due to draw length. Add or
subtract approximately two pounds for each inch your draw
length is over or under the 28” standard.
6