Crestron qm-rmcrx Benutzerhandbuch

Crestron QM-RMCRX  

         QuickMedia™ Receiver/Processor

 

 

These connectors are used for expansion to Cresnet peripherals. Power to the 
unit can be supplied through this connector.  

This male connector can be used to supply 24 VDC power to the  
QM-RMCRX from an external power pack (included). 

CAUTION:  Use only Crestron power supplies for Crestron equipment. 
Failure to do so could cause equipment damage or void the Crestron warranty. 

An 8-position RJ-45 port (labeled LAN) is used for connection to the 
Ethernet, providing local area network or Web access (cable is not supplied). 
The port also contains two light-emitting diodes (LEDs). The green LED on 
the right side of the port is a link status LED and illuminates when the card is 
connected to a working network. The yellow LED on the left side flashes to 
indicate Ethernet activity. Refer to the following table for the Ethernet 
connector signals and use an appropriate cable. Refer to “TCP/IP Connection” 
on page 21 for the RJ-45 connector pinouts. 

 

Two 2-pin terminal block connectors, 5 mm spacing. Left and right amplified 
stereo audio output, 10 watts per channel into 4 or 8 ohms. 

The QM-RMCRX rear panel ports are illustrated and described as follows.  

Pin 1

Pin 2

Pin 3

Pin 4

 

One DIN type connector for S-video output. 

1 Ground 
2 

Ground 

3 Luminance 
4 

Chrominance 

 

NOTE:  S-video contains two separate components, luminance and 
chrominance (also known as Y and C signals respectively). The luminance 
signal contains brightness, intensity, and signal timing information. This signal 
contains all picture information except for color. The chrominance signal 
contains only the color information. You can see the complete black and white 
image, without the chrominance, by only feeding the luminance signal into a 
monitor. 

• 9