Hotpoint wm60 Benutzerhandbuch

● Do not remove hooked end support from drainage hose.

● Do not position standpipe near an electrical outlet.

● For drainage into a standard work top sink ensure outlet pipe has a

minimum bore of 32 mm. To avoid syphoning ensure the end of the drainage

hose is above the water level in the sink. If your sink is inset, the front edge of

the basin must be less than 75 mm from the front edge of your work top.

We recommend one of the following

drainage methods:-

1. Ensure top of standpipe is positioned

at least 500 mm from the floor (Fig 1).

2. Untie the end of the GREY drainage

hose from the rear of the appliance and

place approximately 100 mm into the

standpipe.

3. If the end of GREY drainage hose is 

fitted with ‘Retaining Flaps’, ensure that

they are fully inserted into the stand-

pipe as shown (Fig 2).

1. Untie the end of the GREY drainage

from the rear of the appliance.

2. Reposition ‘Hooked End Support’ as

required along GREY drainage hose.

3. If fitting an under sink waste disposal

unit (Fig 3), cut out the membrane,

bung or blanking plug.

4. Attach the GREY drainage hose to the

under sink waste disposal unit securely,

using a hose clip (Fig 4).

5. Raise the hose to a minimum height 

of 800 mm to avoid syphoning.

● Release locking rings on the two front feet.

● Screw feet in or out until appliance is standing 

firm and level.

● Ensure all feet are in firm contact with the floor.

● Tighten the locking rings on the front feet.

1. Dispose of packaging safely, see 

‘Recycling Information’ on page 

3.

2. Position appliance close to 

electrical/water supply  see  

‘Location’ on page 4.

3. Remove transit bracket & screws see 

‘Transit Bracket Removal’ on 

page 5.

4. Connect supplied hoses to 

appliance water supply, confirm 

water is flowing before connecting 

to the appliance inlet valves 

see ‘Water Supply’ on page 6.

5. Untie drainage hose at rear of 

appliance and connect to either 

a standpipe or sink waste drainage 

system see ‘Drainage’ opposite.

6. Untie mains lead at rear of 

appliance and plug into electrical 

supply via a switched  socket,

see  ‘Electrical Supply’ on page 2.

7. Position appliance, taking care not to 

kink or damage hoses at rear of 

appliance.

8. Stabilise the appliance, see 

‘Adjusting the feet’ opposite.

9. Turn on the water supply 

to the appliance.

10. Switch on at plug socket.

500  mm

Fig 1

Fig 3

Fig 2

Cut

7

Hose Clip

Fig 4