Hatco fshc67m-1104 Benutzerhandbuch

Seite von 16
WARNINGS
Genuine Hatco Replacement Parts are
specified to operate safely in the
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical shock
or burn.
CAUTIONS
To avoid any injury or damage locate the
Holding Cabinet at the proper counter height,
in an area that is convenient for use. The
location should be level to prevent the unit or
its contents from accidentally falling, and
strong enough to support the weight of the
unit and food.
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the
ambient air temperature is constant and is a
minimum of 70°F (21°C).
The unit must be transported in an upright
position. If laid on its side, the water must be
drained from the unit.
CAUTIONS
Water Quality Requirements - Incoming water
in excess of 3.0 grains of hardness per gallon
(GPG) (.75 grains of hardness per liter) must
be treated and softened before being used.
Water containing over 3.0 GPG (.75 GPL) will
decrease the efficiency and reduce the
operating life of the unit.
NOTE: Product failure caused by liming or
sediment buildup is not covered under warranty.
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your Flav-
R-Savor cabinet marring its appearance and
making it susceptible to soil accumulation.
Do not use deionized water. Deionized water
will greatly shorten the life of the water
reservoir and heating element.
Form No. FSHC67M-1104
1
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT! Read the following important safety instructions to avoid personal injury or
death, and to avoid damage to the equipment or property.
WARNINGS
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine the proper voltage and size and
install the proper electrical outlet.
To avoid any injury, turn the power switch
OFF, unplug the unit from the power source
and allow to cool completely before
performing any maintenance or cleaning.
For safe and proper operation, the portable
holding cabinet must be located a reasonable
distance from combustible walls and
materials. If safe distances are not
maintained, discoloration or combustion
could occur.
Overfilling can cause electrical shock. Stop
filling when Low Water light goes off.
To avoid any injury, turn the power OFF to the
unit and allow to cool before draining.
To prevent any injury or damage to the unit do
not pull unit by power cord.
To prevent any injury, discontinue use if
power cord is frayed or worn.
To avoid electrical shock or personal injury,
do not steam clean or use excessive water on
the unit.
Some exterior surfaces on the Holding
Cabinet will get hot. Use caution when
touching these areas to avoid injury.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or
International fax 414-671-3976.
This product has no “user” serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco Service
Agents and Genuine Hatco Parts when
service is required.