Uniden BC246T Benutzerhandbuch

32

Before you use rechargeable batteries for the first time, 
charge them for 14 hours to bring them to a full charge.

Discharged batteries take about 14 hours to fully 
recharge.

You can power the scanner using the supplied 6V, 500 
mA AC adapter.

To use the scanner on AC power, plug the AC adapter 
into a standard AC outlet.

If rechargeable batteries are installed and 
ALKALINE/RECHARGEABLE is set to RECHARGE-
ABLE, the adapter powers the scanner and recharges 
the installed batteries at the same time.

To attach the supplied flexible antenna to the connector 
on the top of your scanner, align the slots around the 
antenna's connector with the tabs on the scanner's BNC 
connector. Then slide the antenna's connector down over 
the scanner's connector and rotate the antenna connec-
tor's outer ring clockwise until it locks into place.

The scanner's BNC connector makes it easy to connect a 
variety of optional antennas, including an external mobile 
antenna or outdoor base station antenna.

Note: Always use 50-ohm, RG-58, or RG-8, coaxial cable 
to connect an outdoor antenna. If the antenna is over 50 
feet from the scanner, use RG-8 low-loss dielectric coax-
ial cable. You can get a BNC adapter at your local elec-
tronics store.