Juniper Networks T1600 Benutzerhandbuch
■
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
(RED), weighted random early detection (WRED)
■
Configurable WAN-PHY mode options:
■
loopback
■
mpls
■
path-trace
■
trigger
■
Virtual Router Redundancy Protocol (VRRP) support
■
Hierarchical shaping
■
Fine-grained queueing and shaping per logical interface at both ingress and egress
■
802.1q virtual LANs (VLANs)
■
VLAN stacking and rewriting
■
Channels defined by two stacked VLAN tags
■
Multiple tag protocol identifiers (TPID) support
■
IP service for nonstandard TPID and stacked VLAN tags
■
802.1p rewrite per channel
■
Flexible mapping of channels and scheduler resources at both ingress and egress
■
Flexible Ethernet encapsulation
■
MAC learning, policing, accounting, and filtering
Software features
■
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
and removing transceivers, see the PIC and Transceiver Installation Instructions.
■
Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
■
Duplex LC/PC connector (Rx and Tx)
■
Optical interface support—See Table 23 on page 56
Cables and connectors
OK LED, one tricolor:
■
Off—PIC is offline and safe to remove from the router.
■
Green—PIC is operating normally.
■
Amber—PIC is initializing.
■
Red—PIC has an error or failure.
APP LED, one:
■
Off—Monitoring application is not running
■
Green—Monitoring application is running under acceptable load
■
Amber—Monitoring application is overloaded
Link Status LED, one:
■
Off—Port is down
■
Green—Port is online. Link is established
LEDs
10-Gigabit Ethernet IQ2 PIC with XFP
■
55
10-Gigabit Ethernet IQ2 PIC with XFP