Juniper Networks T1600 Benutzerhandbuch

■

Optical diagnostics and related alarms

■

Per-port SONET/SDH framing

■

Link aggregation

■

Alarm and event counting and detection

■

Dual-router automatic protection switching (APS)

■

Multiprotocol Label Switching (MPLS) fast reroute

■

Encapsulations:

■

High-Level Data Link Control (HDLC)

■

Frame Relay

■

Circuit cross-connect (CCC)

■

Translational cross-connect (TCC)

■

Point-to-Point Protocol (PPP)

You can install any transceiver supported by the PIC. For information about installing and
removing transceivers, see the PIC and Transceiver Installation Instructions.

■

Duplex LC/PC connector (Rx and Tx)

■

Optical interface support—See Table 35 on page 86, Table 36 on page 87, and
Table 37 on page 87

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid
links, take the PIC offline until you are ready to establish a link to another device. For
information about taking a PIC offline, see the 

request chassis pic offline

 command in the

JUNOS System Basics and Services Command Reference.

One tricolor per port:

■

Off—Not enabled

■

Green—Online with no alarms or failures

■

Amber—Online with alarms for remote failures

■

Red—Active with a local alarm; router has detected a failure

SONET/SDH OC12/STM4 (Multi-Rate) PICs with SFP 

■

85

SONET/SDH OC12/STM4 (Multi-Rate) PICs with SFP