Honeywell MS-9600LSE Benutzerhandbuch

MS-9600LS Series Manual — P/N 52646:B2  2/12/2010

121

Programming



Pressing 3 for ANN-BUS Options, while viewing the Annunciators screen, will cause the following 
screens to be displayed:.

A printer module, graphic annunciator module, LCD annunciator module, LED annunciator mod-
ule and relay module can be programmed into the system.  These devices communicate with the 
FACP over the ANN-BUS terminals on the control panel.

The ANN-BUS must be enabled if any modules are connected to the ANN-BUS terminals.  To 
enable the ANN-BUS, press 1 while viewing ANN-BUS screen #1 so that the display reads 
Enabled Yes.  Each press of the 1 key will cause the display to toggle between Enabled Yes and 
Enabled No.

If an ANN-BUS module is installed, press 2 while viewing ANN-BUS screen #1 to select ANN-
BUS addresses for the module(s).  The following screen will be displayed. 

Pressing the down arrow key will allow the programmer to view additional screens displaying 
Addresses 1-8.  To program an ANN-BUS module to a specific address, press the number key cor-
responding to the desired address in each screen.  The following screen will be displayed for each 
address: 

  ANNUNCIATORS

1=TERM OPTIONS

2=ACS OPTIONS

3=ANN-BUS OPTIONS

Annunciator Screen

       ANN-BUS

1=ENABLED         NO

2=MODULES INSTALLED

3=AUTO-CONFIGURE

       ANN-BUS

1=ANN-S/PG OPTIONS

2=ANN-80 OPTIONS

    ANN-BUS MODULES

1=ADDR. 1    NONE

2=ADDR. 2    NONE

3=ADDR. 3    NONE

    ANN-BUS MODULES

ANN-BUS ADDRESS #

1=TYPE           NONE