bobcat 2200d Benutzerhandbuch
Bobcat 2200 Diesel Vehicle
19
Operation & Maintenance Manual
Returning the Stored Vehicle to Service
1. Make sure the key switch is in the OFF position and
the Forward/Reverse handle is in the NEUTRAL
position. Chock the wheels.
position. Chock the wheels.
2. Restore the fuel system to operation. See Figure 26
on page 34.
2.1. Remove the plug from the fuel tank vent.
2.2. Connect the vent tube to the fuel tank vent.
3. Connect the battery cables, positive (+) cable first,
and tighten the terminals to 27,1 Nm. Coat terminals
with Battery Terminal Protector Spray (1014305 CC).
with Battery Terminal Protector Spray (1014305 CC).
4. Place the Forward/Reverse handle in the NEUTRAL
position. Crank the engine until fuel is pumped into
the fuel lines and the engine starts. Turn the engine
off. See following NOTE.
the fuel lines and the engine starts. Turn the engine
off. See following NOTE.
NOTE: Due to the oil added to the engine in
preparation for storage, the engine may
smoke excessively for a short time when it is
run for the first time after storage.
smoke excessively for a short time when it is
run for the first time after storage.
5. Perform the on page 11.