Jacuzzi post and rail style skirt installation instructions Benutzerhandbuch

Follow these steps to ensure that the bath skirt fits properly.

The optional skirt is designed to allow the minimum service access necessary to the motor/pump and plumbing of the
bath.

Allow clearance of at least 8" in front of bath for skirt removal. The skirt should be attached after the bath has been
installed.

The bath should already be set and levelled.  Electricity
should be connected and bath system tested to be sure
it is working properly before installing the skirt.

Mount the shell clip to the wooden block located under
the bath rim at the center of the rim.  (As shown in
illustration 1.)  The shell clip is to be located about 7/8"
from the inside of the bath rim edge. Mark hole locations
on the block using the clip as a template. Then drill pilot
holes about 1/8" deep using a 3/32" drill bit.  Use caution
to avoid drilling through bath rim.  Secure the clip to
the wooden block with screws as shown.

Insert posts under rim of bath corners in front of the wood
blocks, as shown in illustration 2.  Make sure bottom of
posts are against the floor.  Push top of posts against
inside corners of the bath and fasten the tip of the posts
to the wood blocks as shown using the metal brackets
and fasteners provided.  Check the vertical alignment of
the posts with a level and fasten the bottom of the posts
to the floor as shown.

Mount shell clip to rim at center of bath.

Install the bath per instructions
supplied with the individual product.

90

°

90

°

Check that wall structure is plumb and square to
the floor.  Shim the framing if necessary before
finishing to ensure a square opening.

BATH RIM
(Interior)

SCREWS

(PROVIDED)

7/8"

SHELL CLIP