Intermatic fl100hps Benutzerhandbuch

A qualified electrician should complete all required wiring. This fixture will accept 120, 208, 240 or 277 

Volts AC and must be properly grounded for safety. A mounting suitable for outdoor use and rated for 

wet locations is required. Follow all applicable electrical codes and regulations

.

Disconnect power at circuit breaker or fuse box before installing or servicing light.

USE MIN 60ºC SUPPLY CONDUCTORS.

CONNECT TO SUPPLY IN EXTERNAL JUNCTION BOX ONLY.

Lamp and housing become very hot during use.

Ensure free air circulation around unit to dissipate heat.

Avoid enclosed locations and locations where flammable debris (leaves, cut grass, etc.) might collect.

Avoid locations where humans or animals might accidentally touch fixture.

Never operate light without securing the lens door. When light is operating, the gas in the lamp inner arc tube 

is at high pressure.

Never operate light if the fixture lens or outer glass envelope of the lamp is broken or missing.

Wear safety glasses and gloves when handling lamp, High Pressure Sodium outer envelope is under vacuum 

and could implode.

1. Screw the threaded mounting arm of the fixture into 1/2” NPS mounting hole on mounting device.

Tighten locknut to secure fixture. See Figure 1.

Mount the fixture so lamp is horizontal. (See Figure 2)

INSTALLATION INSTRUCTIONS

Lamp Types: High Pressure Sodium 100 Watt

Models: FL100HPS

Figure 1

Figure 2

Install with lamp horizontal

Clip

Lens 

Cover

Hinge

Mounting

Arm Bolt

Locknut