Nautilus t518 Benutzerhandbuch

1

2-15  Plug the red and black motor wires onto the 

motor controller. The red wire goes on the A+ 
terminal and the black wire goes to the A- 
terminal. Attach the green ground wire to the 
controller/frame with the Phillips head screw 
(see Figure 7 and 7A).

2-16  Replace the motor cover first, then replace the 

lower outer plastic cover using (4) Phillips head 
screws per side, and the lower inside upright 
plastic cover using (4) Phillips head screws, per 
side. 

2-17  Recalibrate the electronics. See the Calibration 

Procedure in Appendix 4.