blue-seal g1100 Benutzerhandbuch

Revision 4/F3576 

© Moffat Ltd, December 2004 

1)  Remove the stainless steel top cover from 

the unit which is to become the bottom 
unit. 

2)  Screw into place the insulation panel over 

the fibre insulation (folded edge forward), 
locating the rear slots of the panel with the 
holes in the chassis member. 

3)  Drill two additional holes through the side 

members to locate with the remaining two 
holes in the insulation panel. 

4)  Locate and attach duct assembly onto top 

of the bottom unit’s flue. 

5)  Unbolt the four legs of the base unit and 

replace with the short legs supplied. 

6)  Remove the legs and leg frame from the 

G1100 top unit. 

7)  Remove the back panel from the top unit. 
8)  Cut out slots in base panel of top unit for 

chimney (refer figure A.2). 

9)  Insert and attach chimney assemblies with 

2 screws each. 

10) Fit side spacers and front cover to bottom 

of top unit. 

11) Stack  the  units,  ensuring  chimney  and 

duct are aligned and spacers line up with 
holes in sides of bottom unit, and secure 
with screws provided. 

12) Attach  rear  spacer  and  re-fit  the  back 

panel on the top unit 

Double Stacking Kit - part number 016393