Bay Technical Associates BayTech DS72 Benutzerhandbuch
DS72 Host Module
10
Figure 4
Network Port Configuration
Figure 5
IMPORTANT: For network access, either Enable the DHCP, BOOTP or disable the DHCP
and BOOTP, then configure the IP addresses, Subnet Mask, and Gateway Address. The module
must be reset for network changes to take effect.
and BOOTP, then configure the IP addresses, Subnet Mask, and Gateway Address. The module
must be reset for network changes to take effect.
Network Configuration
IP Address: 0.0.0.0
Subnet Mask: 0.0.0.0
Gateway: 0.0.0.0
Ethernet Address: 00.C0.48.06.57.4C
Connection Inactivity Timeout (mins): Disabled
Carriage Return Translation: Disabled
Break Length (msecs): 350
DHCP is Disabled Bootp is Enabled Telnet is Enabled
IP Address........................1
IP Address: 0.0.0.0
Subnet Mask: 0.0.0.0
Gateway: 0.0.0.0
Ethernet Address: 00.C0.48.06.57.4C
Connection Inactivity Timeout (mins): Disabled
Carriage Return Translation: Disabled
Break Length (msecs): 350
DHCP is Disabled Bootp is Enabled Telnet is Enabled
IP Address........................1
Ethernet port IP Address 0.0.0.0
Subnet Mask.......................2
Tells when to listen Address 0.0.0.0
Gateway Address...................3
Router/Hub/Switch IP Address 0.0.0.0
Inactivity Timeout................4
Set timeout, in minutes
(<=120,0=disable)
Carriage Return Translation.......5
Enable/Disable
Break Length......................6
Set in milliseconds (<=10000,
0=disable)
Bootp.............................7
Bootp.............................7
Enable/Disable
DHCP..............................8
Enable/Disable
Telnet............................9
Enable/Disable
Exit...........................X,CR
User Management Menu
To change user password, enter number of user.
To add/delete user, select appropriate menu choice.
Enter request, CR to exit menus.
To add/delete user, select appropriate menu choice.
Enter request, CR to exit menus.
A)...Add user
1)...admin
Enter Request :a
1)...admin
Enter Request :a