Zebra Technologies P330i Benutzerhandbuch
Installation and Setup
Loading a Ribbon
980459-001 Rev. A
P330i User’s Manual
13
4.
Gently press the print head carriage down until it is fully lowered, as shown below. Very
little force is neccessary to perform this step.
little force is neccessary to perform this step.
Caution • Do not touch the print head if the printer has been in service within the last 10
minutes. It could be very hot and cause a burn.
minutes. It could be very hot and cause a burn.
Electrostatic Discharge Caution • A static discharge is possible if you touch any
exposed metal parts. Use of an anti-static wrist strap or comparable anti-static protection is
required.
exposed metal parts. Use of an anti-static wrist strap or comparable anti-static protection is
required.
Note •
During normal operation (with power connected and turned on), the ribbon would
automatically synchronize when the Print Head is restored to its fully-down position. The
ribbon would be identified and the corresponding parameters sent to the driver.
Since power is not connected at this point in the Installation and Setup Procedure, nothing
will happen when the Print Head Carriage is closed. The ribbon will synchronize when
power is turned on.
ribbon would be identified and the corresponding parameters sent to the driver.
Since power is not connected at this point in the Installation and Setup Procedure, nothing
will happen when the Print Head Carriage is closed. The ribbon will synchronize when
power is turned on.