Zebra Technologies QL+ Benutzerhandbuch

Seite von 86
33
QL Series User Guide
Wireless Local Area Network (WLAN) Module Using CF Radio
The following section only applies when the CF (Compact Flash) WLAN module (With
FCC ID:  I28MD-RW4137) is installed in a QL Series printer (note that only one of the
radio options can be installed in the printer at one time). The antenna used for this
transmitter must not be co-located or must not operate in conjunction with any other
antenna.
QL model printers have the  FCC ID number label  on the front of the module, and QL
Plus models have the FCC ID number on a label on the back of the unit.
   WARNING: Use of a QL Series printer with the radio module
marked with FCC ID: I28MD-RW4137” meets the FCC requirements
for radio frequency (RF) radiation exposure in the standard body
worn configuration with no minimum separation. In this
configuration, which applies whether the belt clip or shoulder
strap is used, the face of the printer from which paper is
transported is facing away from the user’s body. The standard
configuration must always be used when the printer is body worn.
QL 220/220 Plus, QL 320/320 Plus and QL 420/420 Plus printers with
this radio option have been SAR tested. The maximum SAR value
measured for each model is listed below:
Model
SAR value W/Kg (1g average)
QL220/220 plus
0.0618
QL 320/320 plus
0.0500
QL 420/420 plus
0.0432
European Regulatory Information for this Radio
AT
BE
CY
CZ
DK
EE
FI
FR
DE
GR
HU
IE
IT
LV
LT
LU
MT
NL
PL
PT
SK
SI
ES
SE
GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)
 
0336
 
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.
continued