Zebra Technologies R110Xi Benutzerhandbuch

50

R110Xi/R170Xi User Guide

23063L-003 Rev. 1 12/6/04

Front Panel LCD

MEDIA AND 

RIBBON 
CALIBRATE

Calibrate Media and Ribbon Sensors
Use this procedure to adjust sensitivity of media and ribbon sensors.
Important • 

This procedure must be followed exactly as presented. All of the steps 

must be performed even if only one of the sensors requires adjustment. You may 
press the left oval at any step in this procedure to cancel the procedure.

Press the right oval to start the calibration procedure. 

The 

LOAD BACKING

 prompt displays.

Open the printhead.

Remove approximately 8 in. (203 mm) of labels from the backing, and pull the 
media into the printer so that only the backing is between the media sensors.

Leave the printhead open.

Press the right oval to continue.

The 

REMOVE RIBBON

 prompt displays.

Remove the ribbon.

Close the printhead.

Press the right oval to continue.

The message 

CALIBRATING PLEASE WAIT

 displays.

The printer adjusts the scale (gain) of the signals that it receives from the media 
and ribbon sensors. On the sensor profile, this essentially corresponds to moving 
the peak of the graph up or down to optimize the readings for your application.
When calibration is complete, 

RELOAD ALL

 displays.

Open the printhead and pull the media forward until a label is positioned under 
the media sensor.

Reload the ribbon.

Close the printhead.

Press the right oval to continue.

The printer does a calibration equivalent to pressing 

CALIBRATE

; during this 

process, the printer determines the label length. To see the new readings on the 
new scale, print a sensor profile.

PARALLEL COMM

Setting Parallel Communications
Select the communications port that matches the one being used by the host 
computer.
• Press the right or left oval to display other choices.
Default: BIDIRECTIONAL
Selections: BIDIRECTIONAL, UNIDIRECTIONAL, OR TWINAX/COAX

SERIAL COMM

Setting Serial Communications
Select the communications port that matches the one being used by the host 
computer.
• Press the right or left oval to display other choices.
Default: RS-232
Selections: RS-232, RS-422/485, RS485MULTIDROP