Kenwood KAC-PS541 Benutzerhandbuch

English

� ��

��

�

��

�

��
��

�

��

�

��
��

��

��
��

��

�

��

�

��

��
��

��

�

��

�

��

�

Installation

Accessories

Part name

External View Number of Items

Self-tapping screws

(ø5 × 18 mm)

Hexagon socket head cap screw

(M4 × 8 mm)

Cover

Terminal cover (Power terminal)

Hexagon Wrench

Installation procedure

Since there are large variety of settings and connections possible according to

applications, read the instruction manual well to select the proper setting and

connection.

1. Remove the ignition key and disconnect the negative - terminal of the

battery to prevent short circuits.

2. Set the unit according to the intended usage.

3. Connect the input and output wires of the units.

4. Connect the speaker wires.

5. Connect the power wire, power control wire and grounding wire following this

order.

6. Install the installation fittings in the unit.

7. Attach the unit.

8. Install the terminal cover.

9. Connect the negative - terminal of the battery.

CAUTION

• Do not install in the below locations;

(Unstable location, In a location that interferes with driving, In a location

that gets wet, In a dusty location, In a place that gets hot, In a place that

gets direct sunlight, In a location that gets hit by hot air)

• Do not install the unit under the carpet. Otherwise heat build-up occurs

and the unit may be damaged.

• Install this unit in a location which allows heat to easily dissipate.

Once installed, do not place any object on top of the unit.

• The surface temperature of the amplifier will become hot during use. Install

the amplifier in a place where people, resins, and other substances that are

sensitive to heat will not come into contact with it.

• This unit has cooling fans to decrease the internal temperature. Do not

mount the unit in a place where the cooling fan and ducts of the unit are

blocked. Blocking these openings will inhibit the cooling of the internal

temperature and result in malfunction.

• When making a hole under a seat, inside the trunk, or somewhere else in

the vehicle, check that there is nothing hazardous on the opposite side

such as a gasoline tank, brake pipe, or wiring harness, and be careful not to

cause scratches or other damage.

• Do not install near the dashboard, rear tray, or air bag safety parts.

• The installation to the vehicle should securely fasten the unit to a place in

which it will not obstruct driving. If the unit comes off due to a shock and

hits a person or safety part, it may cause injury or an accident.

• After installing the unit, check to make sure that electrical equipment

such as the brake lamps, turn signal lamps and windshield wipers operate

normally.

Installation board, etc.

(thickness : 15 mm or more)

Self-tapping screw

(ø5 × 18 mm)

Cooling fan

Hexagon socket

head cap screw

(M4 × 8 mm)

Hexagon Wrench

Cover

Cooling fan

Duct

2.KAC-X541_M_1US.indd

04.1.9, 2:15 PM