NEC neax2000 ivs nd-45492 Benutzerhandbuch
ND-45492 (E)
CHAPTER 3
Page 151
Revision 2.0
1. System Initialization
•
There are two methods for System Initialization. The first method is to Clear All Data, except LEN0000 as
a CAT terminal, and then program the System Data. The second method is to use the Resident System Pro-
gram, which causes the system to configure itself automatically to the default settings, wherever the line/
trunk cards are installed. Refer to the System Data Sheet, for the default settings.
a CAT terminal, and then program the System Data. The second method is to use the Resident System Pro-
gram, which causes the system to configure itself automatically to the default settings, wherever the line/
trunk cards are installed. Refer to the System Data Sheet, for the default settings.
•
Turn on the “SW1” switch on all the PZ-PW86 units.
•
The “ON” lamp must be lit on all the PZ-PW86 units.
1.1. All Clear, Except LEN0000 CAT
STEP 1:
On the MP Card, set SW3 to “B” and press SW1.
STEP 2:
When the “MN” lamp on the system is lit, set SW3 to the “0” position and press SW1.
•
The operating mode has been changed to the ON LINE mode.
Note:
Refer to the Circuit Card Manual for information on switch settings.
1.2. Resident System Program
STEP 1:
Mount the Line/Trunk cards into PIM.
STEP 2:
On the MP Card, set SW3 to “C” and press SW1.
•
After 30 to 40 seconds, the “MN” lamp turns on.
•
The system has loaded the Resident System Program.
Note:
If the “MJ” lamp is lit, repeat Step 2.
STEP 1:
Set SW3 to the “0” position and press SW1.
•
The operating mode has been changed to the ON LINE mode.
Note:
Refer to the System Data Sheet for additional information on the Resident System Program and the initial-
ization of the system without a MAT (enabling CAT mode).
ization of the system without a MAT (enabling CAT mode).
NAP 200-010
Sheet 1/3
System Initialization and System Data
Entry
Entry
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
Static Sensitive
Handling
Precautions Required