Navman tracker 5500 Benutzerhandbuch
35
TRACKER 5100/5100i/5500/5500i Installation and Operation Manual
NAVMAN
External GPS antenna
(TRACKER 5500, 5100)
(TRACKER 5500, 5100)
Fuel transducer(s)
(optional)
(optional)
Installation
To fuel tank
To engine
Auto Power Wiring
This option is possible on both the TRACKER 5100
and the TRACKER 5500.
and the TRACKER 5500.
Black Wire: Connect this to the negative battery
terminal.
terminal.
Red Wire: Connect this to the 12 V positive battery
terminal after the main switch. Fit a 1 Amp fuse as
shown.
terminal after the main switch. Fit a 1 Amp fuse as
shown.
Yellow Wire: Connect to the ignition switch
Fuse
Fuse
White (NMEA out)
Green
External Beeper
or Light
or Light
Red
Yellow
Black
Main
switch
switch
12 V DC
Ignition
switch
switch
To ignition system
Fuse
Red
Yellow
Black
Main
switch
switch
12 V DC
Basic Wiring
This option is possible on both the TRACKER 5100
and the TRACKER 5500.
and the TRACKER 5500.
Black wire: Connect this to the negative battery
terminal.
terminal.
Red Wire: Connect this to the 12 V positive battery
terminal after the main switch. Fit a 1 Amp fuse as
shown.
terminal after the main switch. Fit a 1 Amp fuse as
shown.
Yellow wire: Connect this to the black wire.
Power on the TRACKER manually whenever the
main switch is on.
main switch is on.
Power/data cable (black locking collar)
Pin Wire
Signal
1
Black
Ground (power negative, NMEA)
2
Brown
Power out, 9 V DC
3
White
NMEA out, to autopilot/radar
4
Blue
NavBus - or NMEA2 input
5
Red
Positive power in, 11 to 16.6 V DC
6
Orange
NavBus +
7
Yellow
Auto power in (connect to positive
power in to enable auto power)
power in to enable auto power)
8
Green
External beeper or light out,
switched to ground, 30 V DC,
200 mA maximum
switched to ground, 30 V DC,
200 mA maximum
Note: Shield is connected to pin 1, black wire