Desa GMC55FA Benutzerhandbuch
Figure 9 - Screw Locations for Fireplaces with Fixed Louver
Screws
Holes are Behind Louver on
Fireplace Bottom for Attaching
Fireplace to Wooden Mantel
Base.
Fixed
Louver
121559-01
Rev. A
04/07
Rev. A
04/07
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
1-866-672-6040
NOT A UPC
121559 01
instAlling FiRePlACe WithOUt FlAnge
1. Place mantel assembly on wood base and center left to
1. Place mantel assembly on wood base and center left to
right having back of assembly flush with back of base.
2. Attach mantel to base using 6 brackets and 1/2" screws,
3 per leg assembly into threaded holes in base and leg
assembly (see Figure 7, page 3).
3. Position fireplace inside mantel (see Figure 10). Care-
fully position gas lines. IMPORTANT: Use caution when
positioning fireplace on base. Base may scratch easily.
4. Gas fireplace with louver door: Lower bottom louver
door. Use two screws provided in fireplace hardware
package and attach fireplace to wooden base (see Figure
8, page 3). Close louver door
Gas fireplace with fixed louver: Before installing logs or
burner assembly (see owner’s manual) remove screws
securing floor to assembly. Lift floor for access to bot-
tom of fireplace. Use two screws provided in fireplace
hardware package and attach fireplace base to wooden
base (see Figure 9). Reinstall floor with screws removed
previously.
5. Assemble perimeter trim, see Assembling Perimeter
Trim. Firmly snap trim assembly over shoulder screws
on fireplace.
6. Carefully push mantel and base into position against
wall.
Figure 10 - Installing Fireplace without Flange
Figure 11 - assembling metal trim
ASSEmblING PERImETER TRIm (GAS
FIREPlAcE ONly)
FIREPlAcE ONly)
1. Remove packaging from three pieces of metal trim.
2. Locate two adjusting plates with set screws, and two
2. Locate two adjusting plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 11.
4. Slide one end of adjusting plate/shim in slot on mitered
4. Slide one end of adjusting plate/shim in slot on mitered
edge of top trim (see Figure 11).
5. Slide other end of adjusting plate/shim in slot on mitered
edge of side trim (see Figure 11).
6. While firmly holding edges of trim together, tighten both
set screws on the adjusting plate with slotted screw-
driver.
7. Repeat steps 2 through 6 for other corner.
Mantel
Base
Shoulder
Screw
Shoulder
Screw
Side Trim
Slot
Top Trim
Mitered Edge
Shim
Set Screws
Adjusting
Plate
Slot