Dakota Digital mcl-3k-t-r Benutzerhandbuch

MAN#650302-A

GAUGE SETUP

The function switch or trip switch, discussed in the MCL-3000/3006 manual, is used to enter setup mode

for all of the gauges. The first step in the setup procedure is to select which gauge you are going to select to

change a setting. Each gauge will either show a number or a label. If the gauge is showing a label then that

gauge will be selected to enter setup. All of the other gauges will exit setup and allow the selected gauge to be

changed. Press and release the switch to advance through the menus below, when on the desired option press

and hold the switch to select setup for that particular gauge/function. In setup for the air temp gauge you can

only switch units, either degrees Fahrenheit or degrees Celsius.

Speed

Tach

Oil psi

Oil Temp

Fuel

Volt

Air Temp

- 1 -

- 1 - - 1 - - 1 - - 1 - - 1 -

SPd

- 2 - - 2 - - 2 -

- 2 - - 2 -

- 2 -

- 3 -

tCH

- 3 - - 3 -

- 3 -

- 4 - - 4 -

PSI

- 4 - - 4 - - 4 - - 4 -

- 5 - - 5 - - 5 - F or C

- 5 - - 5 -

- 5 -

- 6 - - 6 - - 6 - - 6 -

FUL

- 6 -

- 7 - - 7 - - 7 - - 7 -

- 7 -

uLt

- 7 -

- 8 - - 8 - - 8 - - 8 -

- 8 - - 8 -

AIr

•

Press and hold the push button while turning the key on. Release the switch, and then press and release
the switch watching the setup numbers on all the gauges increment until you get to “

-8-” on the other

gauges and “

AIr”on the new AIR TEMP GAUGE.

•

Press and hold the switch until “

vnt” is displayed in the air temp gauge to jump into setup.

•

Press and release the switch to toggle from “

F ” for degrees Fahrenheit or “ C ” for degrees Celsius.

•

When the desired unit is displayed press and hold the switch until “

---” is displayed to save the

changes.

•

Turn the key off to cycle the power and then back on and all gauges should be in normal mode, setup is
complete.

Sensor

Brake line

Zip tie