Bunn FMD-3 Benutzerhandbuch

32

FIG. 27 RINSE/RUN SWITCH

P1452.40

Location:

The rinse/run switch is located on the lower right

side of the whipper motor mounting panel.

Test Procedures:
1. Disconnect the dispenser from the power source.
2. Check for continuity between the center left ter-

minal and left bottom terminal, also between the
center right terminal and the right bottom termi-
nal with the switch in the rinse (upper) position.
Check for continuity across the center left termi-
nal and the top left terminal, also between center
right right terminal and the right top terminal with
the switch in the run (lower) position . Continuity
must  not be present when the switch is in the
center position.

If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.

FIG. 28 RINSE/RUN SWITCH TERMINALS

P1644

GRY to Control
Board J2-2

GRN to Control
Board J2-9

YEL to Control

 Board J2-3

WHI/BRN to
Door Harness

BLK  from
Main Harness

WHI/BRN to
Door Harness

Removal and Replacement:
1. Open the dispenser door.
2. Remove the facenut securing the run/rinse switch

to the whipper motor mounting panel.

3. Remove switch with wires attached from the back

side of the whipper motor mounting panel.

4. Disconnect the wires from the switch and discard

the switch.

5. Refer to Fig. 28 when connecting  the wires to the

new switch.

6. Install new switch with wires attached through the

hole in the whipper motor mounting panel and se-
cure with facenut.

29170 091598