Delorme pn-60 Benutzerhandbuch

6

For information on setting up your device for the fi rst 

time, see the Quick Start Guide. 

 

 Use two AA batteries (Lithium is recommended; 

you can also use NiMH or alkaline) or a DeLorme 

rechargeable Lithium-ion (Li-ion) battery. 

 

 When the PN-60 is using battery power, the battery 

indicator on the Home Page displays the percentage 

of battery life remaining. 

 

 Remove the batteries when storing the PN-60 for 

a month or longer. 

 

 A slot for an SD card (not included) is underneath 

the batteries inside the battery compartment. 

SD/SDHC/MMC cards up to 32GB are supported.

1. Unscrew the D-rings on the back of the device 

until you can remove the battery cover. 

2. Optional. To insert an SD card, gently press down 

the SD card latch, insert the card in the slot, and press 

down the slot to close the latch. Note  Do not lift 

the SD card latch as this could cause damage.

3. Insert the batteries according to the polarity symbols 

inside the battery compartment. 

4. Replace the back cover and screw in the D-rings.

After you install the batteries, go to Settings > System 

> Battery Type and make sure the correct battery type is 

selected; this ensures that the battery indicator displays 

the correct amount of battery life remaining. 

The battery indicator is on the Home Page; for more infor-

mation, see The Home Page section on  page 16.

1. Install the battery in the device.

2. To leave the device powered on while charging, power 

it on and connect the USB cable to the computer. On 

the Home Page, the battery indicator displays a plug.

OR

To put the device in charging mode, power it off, 

connect the USB cable to the computer, and then 

quickly press Power. The light indicator below the 

Using the PN-60